16600-1LA0A
HITACHI 16600-1LA0A Inyector Directo Infiniti Q50 3.0T QX80 5.6L V8
16600-EY00A, 16600-1LA0B, FIJ0039High-Response Multi-Hole Electromagnetic High-Pressure Nozzle-150 barAplicaciones de vehículos y motores
Especificaciones técnicas
| Especificación | Valor |
|---|---|
| Tipo de sistema | Nissan Direct Injection Gasoline (DIG) 150-bar System |
| Presión de servicioDato clave | |
| Spray Configuration | High-Pressure Laser Multi-Hole Symmetrical Spray Pattern |
| INJECTOR HOLD-DOWN BOLT TORQUE | 10 N·m (89 in-lb) fuel rail mounting bolts📐 Asistente de par y ángulo → |
| FUEL LINE NUT TORQUE | 28 N·m (21 lb-ft) high-pressure delivery pipe flare nut |
| Combustion Seal | High-Density Virgin PTFE Combustion Ring |
| Upper Rail Sealing | Fluorocarbon (FKM) High-Temp Viton O-Ring |
| Manufacturer | Hitachi Astemo (Tier-1 OEM for Nissan Motor Co.) |
| OEM Production Number | 16600-1LA0A / FIJ0039 |
Bomba de alta presión compatible (Ensamblaje del circuito de combustible)
Funciona en el mismo circuito de alta presión Common Rail. Al diagnosticar baja presión (P0087), verifique el caudal de la bomba antes de sustituir los inyectores.
Consejos de instalación
- Never lubricate the lower PTFE combustion seal: Oil degrades the Teflon seal, causing high-pressure combustion blow-by and melted injector bodies.
- Inspect spark plugs on corresponding cylinders: A dripping injector washes fuel down the cylinder, fouling the plug and triggering misfire codes even after injector replacement.
- Verify low-pressure feed pressure: Ensure the tank lift pump delivers stable 5.0 to 6.5 bar (72 to 94 psi) before diagnosing high-pressure injector issues.
- Never reuse high-pressure crossover lines: Metallic flare ends yield upon tightening; reusing them causes dangerous high-pressure fuel sprays onto exhaust manifolds.
Codigos de Falla (DTC) y Protocolos de Diagnostico
Codigos de falla de diagnostico (DTC) comunes que se activan cuando este inyector common rail experimenta desgaste, fallas de circuito o desbalance:
Fuel Rail / System Pressure Too Low
Excessive internal backleak from worn control valve seats drops common rail pressure below target under engine load.
Injector Circuit Malfunction / Open Circuit
Solenoid coil resistance drift (0.2-0.5 Ω) or piezo stack degradation triggers driver stage shutdown on affected cylinders.
Cylinder Misfire & Balancing Deviation
Carbon-clogged nozzle spray holes or missing IMA calibration causes uneven cylinder contribution. Recode ECM and verify washer seating.
Fuel Rail / System Pressure Too High
Spill line backpressure or stuck metering valve prevents rail depressurization, creating overpressure risks under load.
Protocolos Técnicos de Diagnóstico y Servicio
Procedimientos de taller verificados, umbrales de prueba y pautas de servicio para este conjunto.