13537589048

1. [
2. {
3. "step": 1,
4. "title": "Fuel Pressure Depressurization & Battery Disconnect",
5. "instruction": "Disconnect negative battery terminal. Relieve residual 200-bar fuel system pressure by allowing vehicle to cold soak overnight or bleeding through the low-pressure test Schrader port into an approved container."
6. },
7. {
8. "step": 2,
9. "title": "Engine Cowl, Cabin Filter Housing & Intake Charge Pipe Removal",
10. "instruction": "Unclip cabin microfilter harness and remove the cowl tray. Disconnect the upper charge pipe, vacuum canisters, and acoustic engine cosmetic covers to gain unobstructed top access to the fuel rails."
11. },
12. {
13. "step": 3,
14. "title": "High-Pressure Rail & Fuel Line Disconnection",
15. "instruction": "Loosen high-pressure fuel line union nuts using an open-ended flare nut wrench (counter-holding rail hex fittings). Unbolt the hold-down bracket bolts (13 N·m) and carefully extract the old injector using a steady axial pulling motion."
16. },
17. {
18. "step": 4,
19. "title": "Decoupling Element & Teflon Combustion Seal Verification",
20. "instruction": "Ensure the old decoupling support element came out with the injector and is not jammed in the cylinder head. Do not remove the protective plastic cap from the new Index 12 injector until less than 10 minutes before insertion to avoid Teflon expansion."
21. },
22. {
23. "step": 5,
24. "title": "Injector Installation & Hold-Down Bracket Torque Sequence",
25. "instruction": "Install a new decoupling element. Gently insert the Index 12 injector fully into the cylinder head bore. Install hold-down bracket and torque clamping bolts evenly to 13 N·m. Thread fuel line union nuts by hand and torque to 23 N·m."
26. },
27. {
28. "step": 6,
29. "title": "INPA / ISTA 6-Digit Flow Calibration Coding & Leak Test",
30. "instruction": "Connect BMW diagnostic software (ISTA/INPA). Navigate to Service Functions -> Engine Electronics -> Injector Compensation. Enter the printed 6-digit energy code (e.g., 578 214) from the injector body into the corresponding cylinder. Prime system and verify zero fuel leakage."
31. }
32. ]

Häufige Diagnose-Fehlercodes (DTCs), die ausgelöst werden, wenn dieser Common-Rail-Injektor Verschleiß, Schaltkreisfehler oder Kalibrierungsabweichungen aufweist: